Stepper Motor Driver v1.2, a System Module type part.

This board allows you to control one stepper motor (with LED's now!)

More information: make.rrrf.org

Generate Part List

Quantity:

Component Parts

Part	Type	Quantity
.156" 4 position housing	Electronic Component	1
.156" crimp-on connector	Electronic Component	4
.156" header	Electronic Component	4
0.5 ohm 2 watt resistor	Electronic Component	2
10 pin IDC connector	Electronic Component	2
10 pin IDC header	Electronic Component	1
100 nF ceramic capacitor	Electronic Component	3
100 uF electrolytic capacitor	Electronic Component	2
100K ohm resistor	Electronic Component	1
10K trimpot	Electronic Component	1
20 pin DIP socket	Electronic Component	1
22K ohm resistor	Electronic Component	1
3.3 nF ceramic capacitor	Electronic Component	1
4 pin molex connector	Electronic Component	1
560 ohm resistor	Electronic Component	3
5mm green LED	Electronic Component	1
Bicolor LED	Electronic Component	2
big heat sink	Electronic Component	1
L297	Electronic Component	1
L298N	Electronic Component	1
RJ45 Jack	Electronic Component	2
SB360	Electronic Component	8
M3 nut	Fastener	1
M3 washer	Fastener	2
M3 x 10 cap	Fastener	1
Stepper Motor Driver v1.2 PCB	Printed Circuit Board	1
10 pin ribbon cable	Wire	8 inch

Suppliers

Name	Info
MakerBot Industries	/electronics/electronics-kits/stepper-motor-driver-v1-2-kit.html

Where is it used?

This part is not used anywhere.

Embed this part list:

<iframe src="http://parts.reprap.org/embed/module/Stepper+Motor+Driver+v1.2" width="600" height="500" frameborder="0">Visit http://parts.reprap.org/embed/module/Stepper+Motor+Driver+v1.2</iframe>

Wikidot.com embed:

[[iframe http://parts.reprap.org/embed/module/Stepper+Motor+Driver+v1.2 width="600" height="500" frameborder="0"]]