Stepper Motor Driver v1.0, a System Module type part.

This board allows you to control one stepper motor

More information: make.rrrf.org

Generate Part List

Quantity:

Component Parts

Part	Type	Quantity
.100 breakaway header	Electronic Component	15
.100 shunt	Electronic Component	5
.156" 4 position housing	Electronic Component	1
.156" crimp-on connector	Electronic Component	4
.156" header	Electronic Component	4
0.5 ohm 2 watt resistor	Electronic Component	2
1 nF ceramic capacitor	Electronic Component	2
100 nF ceramic capacitor	Electronic Component	3
100 uF electrolytic capacitor	Electronic Component	2
2.7K ohm resistor	Electronic Component	1
20 pin DIP socket	Electronic Component	1
22K ohm resistor	Electronic Component	1
2K trimpot	Electronic Component	1
3 pin header	Electronic Component	2
3 pin housing	Electronic Component	2
3.3 nF ceramic capacitor	Electronic Component	1
4 pin molex connector	Electronic Component	1
4.7K ohm resistor	Electronic Component	2
big heat sink	Electronic Component	1
crimp-on terminals	Electronic Component	6
L297	Electronic Component	1
L298N	Electronic Component	1
SB360	Electronic Component	8
Stepper Motor Driver v1.0 PCB	Printed Circuit Board	1
Cat 6 cable	Wire	2 feet

Suppliers

Name	Info
MakerBot Industries	/electronics/electronics-kits/stepper-motor-driver-v1-2-kit.html

Where is it used?

This part is not used anywhere.

Embed this part list:

<iframe src="http://parts.reprap.org/embed/module/Stepper+Motor+Driver+v1.0" width="600" height="500" frameborder="0">Visit http://parts.reprap.org/embed/module/Stepper+Motor+Driver+v1.0</iframe>

Wikidot.com embed:

[[iframe http://parts.reprap.org/embed/module/Stepper+Motor+Driver+v1.0 width="600" height="500" frameborder="0"]]