Extruder Controller v1.2, a System Module type part.

The extruder controller, ready to control an extruder.

More information: reprap.org

Generate Part List

Quantity:

Component Parts

Part	Type	Quantity
10 nF ceramic capacitor	Electronic Component	1
100 nF ceramic capacitor	Electronic Component	2
10K ohm resistor	Electronic Component	1
180 ohm resistor	Electronic Component	1
2 pin header	Electronic Component	2
2 pin housing	Electronic Component	2
220 ohm resistor	Electronic Component	1
560 ohm resistor	Electronic Component	1
5mm red LED	Electronic Component	1
crimp-on terminals	Electronic Component	4
small heat sink	Electronic Component	1
TIP110	Electronic Component	1
Universal Controller v1.2	System Module	1

Suppliers

No suppliers found.

Where is it used?

Module	Subassembly
RepRap v1.0 "Darwin"	The entire RepRap machine, ready to print.

Embed this part list:

<iframe src="http://parts.reprap.org/embed/module/Extruder+Controller+v1.2" width="600" height="500" frameborder="0">Visit http://parts.reprap.org/embed/module/Extruder+Controller+v1.2</iframe>

Wikidot.com embed:

[[iframe http://parts.reprap.org/embed/module/Extruder+Controller+v1.2 width="600" height="500" frameborder="0"]]